Push the hook (A) with a flat-tip screwdriver through the hole in the front side of the bracket cover (B).
2.
While pushing in the hook (A) with a flat-tip screwdriver, release the sunvisor (B) from the holder (C), and rotate the sunvisor backward 45 °.
NOTE: Make sure the hook slides into the bracket cover (D) as you rotate the sunvisor.
3.
Remove the sunvisor (A).
4.
For some models: Disconnect the connector (B).
2.
Sunvisor Holder - Remove
3.
Sunvisor - Check
1.
If the side curtain airbag has deployed, replace the sunvisor, along with the other parts listed for side curtain airbag deployment.
2.
If the side curtain airbag has not deployed, inspect the sunvisor for damage. A damaged sunvisor may cause the side curtain airbags to deploy improperly, possibly causing injury. Replace the sunvisor if it has any of the following damage:
Any cracks in the sunvisor bracket (A)
Any cracks in the sunvisor bracket cover (B)
Any bends or cracks in the sunvisor shaft (C)
Any cracks in the sunvisor base (D)
Any cracks in the vanity mirror base (E)
3.
If the sunvisor holder is damaged or stress-whitened, replace it with new one.
4.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
