Pull the knuckle (A) outward, and separate the outboard joint (B) from the front hub using a soft face hammer outward, then move aside the knuckle/hub.
NOTE:
Do not pull the driveshaft end outward. The inner driveshaft inboard joint may come apart.
NOTE: Be careful not to damage the ball joint boot when installing the ball joint remover.
7.
All Removed Parts - Install
1.
Install all removed parts in the reverse order of removal.
NOTE:
Be careful not to damage the ball joint boot when connecting the knuckle.
Before connecting the ball joint, degrease the threaded section and the tapered portion of the ball joint pin, the ball joint connecting hole, the threaded section, and the mating surfaces of the castle nut.
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align the castle nut by loosening it.