|
TPMS Calibration
|
|
Make sure the tire pressure is properly adjusted to the specified tire pressure listed on the doorjamb label before doing the TPMS calibration. | |
|
|
The calibration begins when the calibration is selected through the Multi-information display or the TPMS switch is pressed. The calibration is completed after driving in an ideal driving condition (28 to 65 mph (45 to 105 km/h), driving steadily without much acceleration or deceleration) for about 20 minutes. Full functionality of the system cannot be performed properly if the calibration is not completed. | |
|
|
Do the TPMS calibration after doing the following items. |
|
|
? |
Adjust the tire pressure. | |
|
|
|
? |
Update the VSA modulator-control unit. | |
|
? |
Replace the VSA modulator-control unit. | | |
|
|
Calibration check method.
|
|
|
Check if the calibration is completed by doing the following items. |
|
|
1. |
Stop the vehicle and shift into P or N position/mode. | |
|
2. |
Turn the vehicle to the OFF (LOCK) mode. | |
|
3. |
Turn the vehicle to the ON mode and wait to see the low pressure/TPMS indicator come on for 2 seconds and then off. | |
|
4. |
Do not drive the vehicle and wait for 45 seconds as is. | |
|
5. |
If the calibration is completed, the indicator does not come on. If the calibration is not yet completed, then the indicator comes on for 2 seconds and then goes off. | | |
The calibration check process gets interrupted if the vehicle moves. Do the troubleshooting if the indicator does not go off after 2 seconds, keeps blinking or stays on when the vehicle is in the ON mode. |
1. |
TPMS - Calibrate (Without TPMS Switch) |
|
With display audio type (7-inch screen)
|
|
|
With color audio type (5-inch screen)
|
|
2. |
TPMS - Calibrate (With TPMS Switch) |
|