VTC Oil Control Solenoid Valve Removal, Installation, and Test

NOTE: Although a numbered sequence is shown, these "*1" indicated parts are separate components. If removal or replacement of one of the components is needed, it is not necessary to remove the other.


1


1596_3.0_enu_14724426_5.0

enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)
enu_12714524_1.0
Replace

VTC Oil Control Solenoid Valve

1. VTC Oil Control Solenoid Valve - Remove


2. All Removed Parts - Install
1.
Install the parts in the reverse order of removal with a new O-ring.
Coat the new O-ring with clean engine oil.
Clean and dry the mating surface of the valve.

VTC Strainer

1. VTC Strainer - Remove


2. All Removed Parts - Install
1.
Install the parts in the reverse order of removal with a new filter.

1. VTC Oil Control Solenoid Valve - Test
1.
Check for any blockage in the ports of the VTC oil control solenoid valve.
2.
Connect VTC oil control solenoid valve 2P connector (male terminals) No. 1 to the 12 volt battery positive terminal with a jumper wire:
Connect VTC oil control solenoid valve 2P connector (male terminals) No. 2 to the 12 volt battery negative terminal with a jumper wire:




3.
Measure the clearance of the valve (A). The clearance should be at least 1.2 mm (0.047 in).
If the clearance is as specified, the valve is OK; reinstall it with a new O-ring (B).
If the clearance is not as specified, install a new valve and O-ring.