Attach a wrench to the drive belt auto-tensioner (A) and move it in the direction shown. Fix the drive belt auto-tensioner by aligning the water passage hole with drive belt auto-tensioner hole and inserting a 6 x 45 mm (15/64 x 1.77 in) pin (B) deep into the holes.
NOTE: This is a hydraulic type auto-tensioner, so you must turn the wrench slowly.
2.
Remove the drive belt (C).
4.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
1.
Drive Belt - Inspect
1.
Inspect the belt for cracks or damage. If the belt is cracked or damaged, replace it.
2.
Check the position of the drive belt auto-tensioner indicator pointer (A) is within the standard range (B) as shown. If it is out of the standard range, replace the drive belt.