Drive Belt Removal, Installation, and Inspection

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1


1823_3.0_enu_14740940_5.0

enu_12713377_2.0
Detailed information, notes, and precautions

1. Drive Belt - Remove
1.
Set a wrench on the drive belt auto-tensioner (A), and slowly turn the wrench in the direction of the arrow, then remove the drive belt (B).

NOTE: This is a hydraulic type auto-tensioner, so you must turn the wrench slowly for at least 3 seconds.

2. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.

1. Drive Belt - Inspect
1.
Inspect the belt for cracks or damage. If the belt is cracked or damaged, replace it.
2.
Check the position of the drive belt auto-tensioner indicator's pointer (A) is within the standard range (B) as shown. If it is out of the standard range, replace the drive belt.
NOTE: When replaced a new drive belt, check the position of the drive belt auto-tensioner indicator's pointer is within the standard range (C) as shown.

2. Maintenance Minder - Reset (With Maintenance Minder System)
1.
If the Maintenance Minder required to replace the drive belt, reset the Maintenance Minder with the gauge (see "Resetting the Maintenance Minder").