Pulley End Crankshaft Oil Seal Replacement - In Car
Special Tools Required
Image Description/Tool Number
310169.png Driver Handle, 15 x 135L 07749-0010000
420130.png Hub Dis/Assembly Tool, 42 mm 07GAF-SD40200

NOTE: enu_12713377_2.0 Where icon is shown, click for further information.


1


1909_3.0_enu_14741420_5.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714524_1.0
Replace

2. Pulley End Crankshaft Oil Seal - Remove


3. Pulley End Crankshaft Oil Seal - Install
1.
Clean and dry the crankshaft oil seal housing.
2.
Apply a light coat of new engine oil to the lip of the pulley end crankshaft oil seal.
3.
Using the driver handle, 15 x 135L and the hub dis/assembly tool, 42 mm, drive in the new pulley end crankshaft oil seal (A) squarely into the chain case to the specified installed height.
4.
Measure the distance between the chain case surface (A) and the oil seal (B).
Oil Seal Installed Height:
5.4?6.1 mm (0.213?0.240 in)
5.
Clean the excess oil off the crankshaft, and check that the oil seal lip is not distorted.

4. All Removed Parts - Install
1.
Install the parts in the reverse order of removal.