Remove the oil filler plug (A) and the sealing washer (B).
2.
Remove the drain plug (A) and the sealing washer (B), then drain the rear differential fluid.
3.
Remove metal particles from the magnetic surface of the drain plug (A).
4.
Install the drain plug with a new sealing washer (B).
5.
Refill the rear differential with rear differential fluid to the proper level.
NOTE: If you disassemble the differential, check the rear differential fluid level again after the AWD with intelligent control system check is finished. Add fluid if necessary.
Fluid Capacity:
1.2 L (1.3 US qt) at fluid change
1.5 L (1.6 US qt) at overhaul
Recommended fluid:
Honda DPSF-II
6.
Install the oil filler plug (A) with a new sealing washer (B).
3.
Rear Differential Fluid After Replacement - Check
1.
Apply the parking brake and block all wheels.
2.
Start the engine and let it idle more than 6 seconds, then turn the engine off. Repeat this step three more times.
3.
Shift the transmission to D position/mode while pressing the brake pedal firmly. Press the accelerator pedal for 2 seconds, then let it idle. Repeat this step three more times.