Shift Lever Removal and Installation
SRS components are located in this area. Review
the SRS component locations
and
the precautions and procedures
before doing repair or service.
NOTE:
Where icon is shown, click for further information.
1
Detailed information, notes and precautions
Torque: N·m (kgf·m, lbf·ft)
1.
Shift Lever Panel - Remove
2.
Center Console - Remove
3.
Shift Cable (Shift Lever Side) - Remove
4.
Shift Lever - Remove
5.
Shift Lever Bracket Base - Remove
1.
If necessary, removed the shift lever bracket base.
6.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Tighten the shift lever bracket base bolts and nut in the sequence shown to exploded view.
Be sure to
adjust the shift cable
before installing the shift cable.
7.
Shift Lever - After Install Check
1.
Turn the vehicle to the ON mode.
2.
Move the shift lever to each position, and check that the shift position indicator follows the shift lever operation.
3.
Shift the transmission to P position/mode, and check that the shift lock works properly.
4.
Push the shift lock release, and check that the shift lever releases. Also check that the shift lever locks when it is shifted back to P.
5.
Start the engine.
NOTE: Check that the engine starts in P or N position/mode, and does not start in any other positions/modes.
6.
Make sure the vehicle is turned to the OFF (LOCK) mode with the shift lever in P position/mode. If it is not,
adjust the shift cable
again.