Audio Unit Removal and Installation
SRS components are located in this area. Review the
SRS component locations
and the
precautions and procedures
before doing repairs or service.
NOTE:
Where icon is shown, click for further information.
When working on electronic components, make sure the work area is clean and dust free.
Make sure your hands are clean and free of oils and grease.
If you are replacing the audio unit, write down the audio presets (if possible), and enter them into a new audio unit.
1
Detailed information, notes, and precautions
Torque: N·m (kgf·m, lbf·ft)
2
Detailed information, notes, and precautions
1.
Climate Control Panel - Remove
2.
Audio Unit Assembly - Remove
NOTE:
When installing, make sure all the connectors are secure.
After Installation,
do the System Links in the System Diagnostic Mode
to confirm that there are no problems in the system.
3.
Audio Unit Bracket - Remove
4.
Audio Panel - Remove
NOTE:
Discharge static electricity from your body before and during the work.
Do not touch the circuit board(s) with your bare hands.
5.
Volume/List Knob - Remove
If necessary, remove the knob(s).
6.
All Removed Parts - Install
Install the parts in the reverse order of removal.