Audio-Navigation Unit Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
enu_12713377_2.0 Where icon is shown, click for further information.
When working on electronic components, make sure the work area is clean and dust free.
Make sure your hands are clean and free of oils and grease.
When the audio-navigation unit is replaced or disconnected, do the Map Matching. This part of the initialization matches the GPS coordinates with a road on the map screen. To do this part of the procedure, make sure that the navigation system displays a map, and drive the vehicle on a mapped road shown on the map screen. Do not enter a destination at this time. When the name of the current road you are driving on appears at the bottom of the screen, the entire procedure is complete.


1


3702_3.0_enu_14796303_5.0

enu_12713377_2.0
Detailed information, notes, and precautions
enu_12714505_1.0
Torque: N·m (kgf·m, lbf·ft)

2. Audio-Navigation Unit Assembly - Remove

NOTE:
When installing, make sure all the connectors are secure.
If the audio-navigation was replaced, it may take up to 30 minutes for the navigation system to calibrate and operate correctly.
After Installation, do the System Links in the System Diagnostic Mode to confirm that there are no problems in the system, then park the vehicle outside, and do the GPS initialization.

3. Audio-Navigation Unit Bracket - Remove


5. Volume Knob - Remove

If necessary, remove the knob.

6. All Removed Parts - Install

Install the parts in the reverse order of removal.