Side Curtain Airbag Removal and Installation

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:
How to read the torque specifications.
If replacing the side curtain airbag after deployment, refer to Component Replacement/Inspection After Deployment for a complete list of other parts that must also be replaced.
Review the interior trim replacement procedure before doing repair or service.


NOTE: Wait at least 3 minutes before starting work.

3. Side Curtain Airbag - Remove
1.
Pull up on both locking tabs (A) to disconnect the connector (B).
NOTE: Be careful not to damage the connector.
2.
Remove the bolts (A, B).
NOTE: Depending on the model, the side curtain airbag mounting bolts are either a 5mm or 6mm bolt.
3.
For some models: Remove the bolt (C).
4.
Remove the side curtain airbag (D).

4. All Removed Parts - Install
1.
Install all of the removed parts in reverse order.
NOTE:
During installation, install the new side curtain airbag mounting bolts to the specified torque.
If the side curtain airbag is frayed, or has any other visible damage, replace it. Do not attempt to repair an airbag.
When you install the side curtain airbag, make sure it is not twisted, and that it is not caught between the inflator bracket by the bracket bolts.
Make sure that the side curtain airbag inflator retainer is installed properly. Otherwise the side curtain airbag could incorrectly deploy and cause damage or injuries.
If there is any damage to the side curtain airbag, do not try to repair it. Replace any damaged side curtain airbag.
Before installing the headliner, make sure the SRS indicator works normally.

5. SRS Operation - Confirm
1.
Do the 12 volt battery terminal reconnection procedure, turn the vehicle to the ON mode, and check that the SRS indicator comes on for about 6 seconds and then goes off.