Electric Parking Brake Actuator Removal and Installation
NOTE:
How to read the torque specifications
.
1.
Vehicle - Lift
2.
Rear Wheel - Remove
3.
Electric Parking Brake Actuator - Remove
1.
Disconnect the connector (A).
NOTE: If the connector lock tab is difficult to release, push in on the connector body before pushing on the release lock.
2.
Remove the electric parking brake actuator (B).
NOTE: Use new mounting screws during reassembly.
3.
Remove the O-ring (C).
NOTE:
Replace the O-ring whenever the electric parking brake actuator is removed.
When installing the actuator, make sure there is no foreign matter on the mating surfaces and the O-ring.
4.
All Removed Parts - Install
1.
Install all removed parts in the reverse order of removal.
5.
Electric Parking Brake Actuator After Install - Check
1.
Turn the vehicle to the ON mode.
2.
Apply and release the parking brake 2 times, then make sure that the brake system indicator (red) goes OFF.
NOTE: If the brake system indicator (red) does not go OFF, check for a poor connection at the electric parking brake actuator connector.
3.
Turn the vehicle to the OFF (LOCK) mode.