NOTE: Do not allow dust, dirt, or other foreign materials to enter the steering gearbox.
1
Detailed information, notes and precautions
Torque: N·m (kgf·m, lbf·ft)
Replace
1.
EPS Motor/Control Unit - Install
1.
Install a new O-ring (A) to the EPS motor/control unit (B).
NOTE: Apply steering grease to the O-ring if necessary.
2.
Check the rubber bush (C) and motor bush (D) for damage and cracks. If the rubber bush and motor bush are cracked, replace the rubber bush and motor bush.
NOTE: If the rubber bush and motor bush are removed, apply steering grease to the rubber bush and motor bush, then install them to the EPS motor/control unit.
3.
Install the EPS motor/control unit, but do not install the mounting bolts.
4.
Turn the EPS motor/control unit two or three times to the right and left about 45 degrees.
5.
Loosely install the EPS motor/control unit mounting bolts (E) by hand but do not tighten.
NOTE: Make sure the EPS motor/control unit is evenly seated.
6.
Tighten the EPS motor/control unit mounting bolts to the specified torque.