Engine Mount Tightening Procedure

NOTE:
How to read the torque specifications.
Reinstall the mounting bolts and support nuts in the sequence given in the following steps. Failure to follow this sequence may cause excessive noise and vibration, and reduce engine mount life.

1. Jack - Remove


2. Engine/Transmission Mount/Torque Rod - Tightening Procedure

NOTE: When installing the side engine mount, tighten the - bolts at first and temporarily tighten the - bolt while attaching the side engine mount bracket to the side engine mount, then tighten other remaining bolts and nuts as the corresponding procedures that can be seen on the following table.

Tightening Sequence
Mount Removed
Mount Tightening Sequence
Side Engine Mount:
, , , and
Transmission Mount:
, , and
Lower Torque Rod:
and
Upper Torque Rod:

Tightening Torque
Mount No.
Mount Name
Mount Bolt/Nut Tightening Sequence
Side Engine Mount
49 N·m
(5.0 kgf·m, 36 lbf·ft)
Replace.
55 N·m
(5.6 kgf·m, 41 lbf·ft)
Replace.
55 N·m
(5.6 kgf·m, 41 lbf·ft)
Replace.
75 N·m
(7.6 kgf·m, 55 lbf·ft)
Replace.
75 N·m
(7.6 kgf·m, 55 lbf·ft)
Replace.
Transmission Mount
75 N·m
(7.6 kgf·m, 55 lbf·ft)
Replace.
50 N·m
(5.1 kgf·m, 37 lbf·ft)
Replace.
50 N·m
(5.1 kgf·m, 37 lbf·ft)
Replace.
    
Lower Torque Rod
45 N·m
(4.6 kgf·m, 33 lbf·ft)
Replace.
75 N·m
(7.6 kgf·m, 55 lbf·ft)
Replace.
      
Upper Torque Rod
40 N·m
(4.1 kgf·m, 30 lbf·ft)
Replace.
40 N·m
(4.1 kgf·m, 30 lbf·ft)
Replace.