NOTE: Replace if cracked or if mating surface is damaged.
11.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
NOTE:
Tighten the bolts/nuts in three steps; tighten the bolts/nuts until the bolts/nuts sit on the intake manifold, tighten the bolts/nuts until the gasket is compressed, tighten the bolts/nuts to specified torque.
Turn the vehicle to the ON mode, but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel rail will be pressurized. Repeat this two or three times, then check for fuel leakage.
After installation, check that all tubes, hoses, and connectors are installed correctly.