Install the parts in the reverse order of removal.
1.
Cruise Control Combination Switch - Test
1.
Measure the resistance between the cruise control combination switch 12P connector (male terminals) terminals No. 5 and No. 6 according to the table.
If there is no resistance in one or more positions, replace the cruise control combination switch.
Position
Resistance
OFF (Released)
About 2.2 k?
CRUISE/MAIN (Pressed and held)
About 60 ?
CANCEL (Pressed and held)
About 190 ?
SET - (Pressed and held)
About 450 ?
RES + (Pressed and held)
About 900 ?
2.
Check the LED for illumination by applying power and ground to the terminals according to the table.
NOTE: Important operating characteristic; diode bias causes a diode to fully conduct electricity in one direction (forward), while not at all in the opposite direction (reverse).
If the results are not as specified, replace the cruise control combination switch.