AWD Control Unit Removal and Installation
2. AWD Control Unit - Remove
1.
Turn the vehicle to the OFF (LOCK) mode.
2.
Loosen the AWD control unit mounting bolts (A) and remove the AWD control unit (B).
3.
Disconnect connector (C) by pushing the lock (D) and pulling up the lever (E); the connector disconnects itself.


NOTE:
How to read the torque specifications.
The AWD control unit must be initialized after replacement, otherwise the AWD with intelligent control system will not function.

1. AWD Control Unit - Install
1.
Align the connecting surface of the connector (A).
2.
Pull down the lever (B) of the connector, then confirm the connector is fully seated.
3.
Install the AWD control unit (C).