Prying on the automatic lighting/rain sensor bracket (A) may cause damage to the bracket. Insert a pick tool (B) from inside the clip (C) as shown, and carefully remove the clip. Be careful not to damage the windshield with the tip of the pick tool while working.
NOTE: Hold the connector portion, and carefully remove the automatic lighting/rain sensor and silicon sheet together from the glass surface.
Note for installation
Make sure that there are no air bubbles between the windshield glass and silicon sheet during installation.
If the automatic lighting/rain sensor connector is connected after the 12 volt battery terminal is connected, the automatic lighting/rain sensor is not confirmed by the body control module.
If the body control module does not confirm the automatic lighting/rain sensor, the automatic wiper system does not work.
3.
All Removed Parts - Install
1.
Install the parts in the reverse order of removal.
