DTC Troubleshooting: B2A60-54, P2583-54

DTC B2A60-54: Static Camera Aiming Incomplete
DTC P2583-54: Millimeter Wave Radar Aiming Incomplete

NOTE:

Before you troubleshoot, review the general troubleshooting information.

These DTCs are recorded when aiming is not performed or aiming is not successfully completed.

If a DTC is recorded again after it is cleared with the HDS, perform the aiming procedure below:

?	B2A60-54: Aim the multipurpose camera.
?	P2583-54: Aim the millimeter wave radar.

The functions of the integrated driver support system that will be temporarily canceled when this DTC is recorded can be confirmed with the DTC troubleshooting index.

DTC Description	DTC
B2A60-54 Static Camera Aiming Incomplete
P2583-54 Millimeter Wave Radar Aiming Incomplete

Problem verification:

Problem verification

?1.	Turn the vehicle to the ON mode.

?2.	Clear the DTC with the HDS.

?3.	Turn the vehicle to the OFF (LOCK) mode.

?4.	Turn the vehicle to the ON mode, then wait for at least 6 seconds.

?5.

Check for DTCs with the HDS.

DTC Description	DTC
B2A60-54 Static Camera Aiming Incomplete
P2583-54 Millimeter Wave Radar Aiming Incomplete

Is DTC B2A60-54 or P2583-54 indicated?


	YES

The failure is duplicated. Aiming is incomplete. Aim the millimeter wave radar or the multipurpose camera.?


	NO

Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting.?