DTC Troubleshooting: P2715
DTC P2715: Pressure Control Solenoid D Stuck On
NOTE: Before you troubleshoot, review the General Troubleshooting Information.

DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P2715 Pressure Control Solenoid D Stuck On
      

1.
Problem verification:

Problem verification
?1.
Turn the vehicle to the ON mode.

?2.
Clear the DTC with the HDS.


?3.
Start the engine. With the brake pedal pressed, Shift the transmission to N position/mode, then shift to D position/mode. Release the brake pedal, and test-drive the vehicle in D position/mode at speeds 12 mph (20 km/h) or below for at least 10 seconds.

?4.
Turn the engine off. Repeat the test-drive in step 1-3 again.

?5.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P2715 Pressure Control Solenoid D Stuck On
      

Is DTC P2715 indicated??

     
YES
     
     
     
The failure is duplicated. Faulty CVT lock-up clutch control solenoid valve. Replace the valve body assembly.?
     
NO
     
     
     
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?