P2818 Shift Solenoid Valve O/P (Pressure Control Solenoid H) Stuck On
1.
DTC check:
DTC check
?1.
Turn the vehicle to the ON mode.
?2.
Clear the DTC with the HDS.
?3.
Start the engine. With the brake pedal pressed, Shift the transmission to N position/mode, then shift to D position/mode. Release the brake pedal, and test-drive the vehicle in D position/mode at speeds 25 mph (40 km/h) or below for at least 10 seconds.
?4.
Turn the engine off. Repeat the test-drive in step 1-3 again.
?5.
Check for Pending or Confirmed DTCs with the HDS.
DTC Description
Confirmed DTC
Pending DTC
Freeze Frame
P2818 Shift Solenoid Valve O/P (Pressure Control Solenoid H) Stuck On
Is DTC P2818 indicated?
YES
The failure is duplicated. Go to step 2.
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.?
2.
Shift Solenoid Valve O/P operation check:
Shift Solenoid Valve O/P operation check
?1.
Select the Shift Solenoid Valve O/P Test in the Miscellaneous Test Menu, and check that the shift solenoid valve O/P operates with the HDS.