Rear Brake Caliper Removal and Installation

NOTE:

1.	Vehicle - Lift

2.	Rear Wheel - Remove

3.	Parking Brake - Release

NOTE: Only necessary if the automatic parking brake function is turned on.

4.	Connector (Electric Parking Brake Actuator) - Disconnect

5.	Brake Hose - Remove

6.	Brake Caliper Body - Remove (If necessary)

7.	Brake Caliper - Remove

8.	Electric Parking Brake Actuator - Remove (If necessary)

9.	All Removed Parts - Install

Install all removed parts in the reverse order of removal.

10.	Brake System - Bleed

11.	Brake Caliper After Install - Check

Turn the vehicle to the ON mode.

Apply and release the parking brake 2 times, then make sure that the brake system indicator (red) goes OFF.

NOTE: If the brake system indicator (red) does not go OFF, check for a poor connection at the electric parking brake actuator connector.

Turn the vehicle to the OFF (LOCK) mode.